The engine manifold cross over pipe passes the exhaust gas from the driver’s side manifold over to the passenger’s side manifold before flowing into the turbo.

The toyota factory pipe is only 35mm and has restrictions throughout, effecting the gas flow. The Legendex 2” (50mm) pipe is designed by our exhaust engineers to maximise the flow. This in turn increases the turbo spool up which increases responsiveness and improves low end torque.

The pipe gives a smoother throatier note and increases turbo whistle while lowering EGT temps.

Manufactured in our Brisbane factory this high quality manifold pipe includes:

• Ceramic coating is standard (black) – Allowing the pipe to run 50 degrees cooler than factory
• One Piece Design
• 10mm flange plates
• Fitting Kit and easy to follow instructions
• Boxed and bubble wrapped for freight
• Freighted Australia wide with insurance in a prompt time frame

Please Note:

• Reuse the factory manifold gaskets
• Use High Silicone Sealant both sides and each layer on the inside of the gasket